The first rule of the bend region is to have no vias in the region or even the immediate vicinity. Vias are like little I-beams through the z-axis that act to stiffen the flex. Flexing them against their will causes them to crack and fail. When an FPC is bent, there is compression of the inner side of the bend and elongation on the outer side. Something has to give. The most reliable place for routing is right in the middle of the stack-up.
Altium Designer 14 Crack
The edge of the flex material should have a copper line that serves as a tear stop to prevent any cracks from propagating to the signal traces. This is especially critical on any inside bends of the outline. It is common to have a flexible area just after the connector where the outline gets wider to accommodate the connector. That creates an inside bend at exactly the wrong spot. All of the traces are being funnelled into the flex zone.
Trực Tiếp đá Bóng Việt Nam Vs Lebanon. Xem Truc Tiep Bong Da. Futsal Việt Nampes 2020 full crackĐây có lẽ rằng là trường hợp của đi thay nhân viên" khá như mong muốn đối cùng với Ben McLemore. Thiếu chút nữa tay ném của Los Angeles Lakers đã có thể bắt gặp hiểm họa nghiêm trọng. Cập nhật kết quả trận nước ta vs Lebanon thuộc play-off vòng loại Futsal World Cup 2021. 2ff7e9595c
Comments